Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MQ2 Combustible Gas sensor circuit

Status
Not open for further replies.
demetal

demetal

Full Member level 5
Joined
May 2, 2011
Messages
275
Helped
21
Reputation
42
Reaction score
21
Trophy points
1,298
Location
Kingdom Of Kochi
Activity points
3,173
Hi,

i want to built a Combustible gas sensor circuit using the 6 pin gas sensor MQ2 (winsen)... to interface with microcontroller... now i only want to operate a relay without using a microcontroller...

I dont know how to connect the pins... if any one have schematic please help.....




Thankyou.
 

Attachments

  • Gøthíç Stãr0230.jpg
    Gøthíç Stãr0230.jpg
    10.9 KB · Views: 88
  • Gøthíç Stãr0228.jpg
    Gøthíç Stãr0228.jpg
    12.7 KB · Views: 83
  • MQ2 Datasheet.pdf
    179.4 KB · Views: 158

Read the datasheet:
The sensor need to be put 2 voltage:
heater voltage（VH） and test voltage（VC）.
VH used to supply certified working temperature to the sensor, while VC used to detect voltage (VRL) on load resistance （RL）whom is in series with sensor. The sensor has light polarity, Vc need DC
power. VC and VH could use same power circuit with precondition to assure performance of sensor. In order to make the sensor with better performance,
suitable RL value is needed: Power of Sensitivity body(Ps):
Ps=Vc2×Rs/(Rs+RL)2
Click to expand...

Vh=5V

---------- Post added at 12:17 ---------- Previous post was at 12:14 ----------

**broken link removed**

Gas%20sensor.gif


**broken link removed**
 
i want circuit which uses IC HA17358B ( dual opamp) and IC HEF40106B..... please help.....
 

check this 1
Accident-prevention-and-security-system-for-Automobiles3_0.jpg

it may help u but the sensor is MQ303A
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top