Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PicKit 2 Clone Doubt: Programming PIC32MX

Status
Not open for further replies.

picforall007

Junior Member level 3
Joined
Jan 10, 2010
Messages
27
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
India
Activity points
1,458
PicKit 2 Clone Doubt

Is it possible to program PIC32MX controllers using PicKit2 clone lite (My PicKit is not capable of producing VDD other than 5v).

Can I use Resistor network for programming PIC32 OR is DIRECT PROGRAMMING possibe???
 

Re: PicKit 2 Clone Doubt

My PicKit2 clone ckt is shown below.
**broken link removed**


My doubt is very very simple. Can I program 3.3v PIC controllers like PIC32 using the above circuit.


Please help me.
 

Re: PicKit 2 Clone Doubt

picforall007 said:
My PicKit2 clone ckt is shown below.
**broken link removed**
My doubt is very very simple. Can I program 3.3v PIC controllers like PIC32 using the above circuit.Please help me.
Its is recomended to drop down the 5volts to 3.3 volts so as to use the Pickit2 clone with 3.3. volt devices. You may use a resistor + Zener diode combination for safety. But first confirm that your device is supported by the programmer. Cheers.
 

Re: PicKit 2 Clone Doubt

What abt the VPP.
Does it require 12v.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top