Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to test the optocoupler MOC7811 ??

Status
Not open for further replies.
K

Kavitha Seetharaman

Newbie level 2
Joined
Jan 20, 2011
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,292
Hii ..

I'm using the optocoupler MOC7811 for my project . But i dont know how to check it whether it's working or not ... Can anyone help me getting its circuit .... Also, please tell me thw working of this optocoupler ....

Thank u
- Kavitha
 

slotted couplers can be checked crude methode
apply 5 volts DC at transmitter anode pin 3 through a 220 ohm resistor.
and -ve to pin 1.
connect analog meter at reciever side keeping it to 1x ohm position and meter -ve prob at pin 2 and +ve probe at pin 4
of coupler. meter needle will move towads zero.
as you disconnect meter will show infinity.

if you want to test its speed you have to go for its funtional test.
 
You can use your DMM diode test feature for both elements as you would for a diode and transistor junction.

MOC7811 datasheet: **broken link removed**
 

how we wanna know whether the moc7811 have interrupt in it

---------- Post added at 21:03 ---------- Previous post was at 20:35 ----------

if we give power supply to moc7811, thus moc7811 will glow like an led or not?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top