Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

transistor sizing and transimpedance gain

Status
Not open for further replies.
R

ricopt

Member level 5
Joined
Jun 8, 2010
Messages
80
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,807
Can anyone tell me how W/L affect transimpedance gain ?
From my simulation result, If i increase W/L, transimpeance gain will decrease
Is it correct ?
is there any reference i can find ?
 

you can check this application note:

**broken link removed**

Hope this help

---------- Post added at 03:03 ---------- Previous post was at 02:58 ----------

Tell me what you are trying to do ? are you trying to design a transimpedance amplifier ?
 
  • Like
Reactions: ricopt

    R

    ricopt

    Points: 2
    Helpful Answer Positive Rating
What do you do with the L? For common source stage, the gain will depend on gm.ro. If you have same w and smaller L (though w/L is increased), gm will increase by a little while ro will be reduced more. And gm.ro might be smaller.
 
  • Like
Reactions: ricopt

    R

    ricopt

    Points: 2
    Helpful Answer Positive Rating
For L, i make it minimal 0.18um

---------- Post added at 15:53 ---------- Previous post was at 14:50 ----------
masa_2010 said:
you can check this application note:

**broken link removed**

Hope this help

---------- Post added at 03:03 ---------- Previous post was at 02:58 ----------

Tell me what you are trying to do ? are you trying to design a transimpedance amplifier ?
Click to expand...



Ya bro, doing transimpedance amplifier

---------- Post added at 15:55 ---------- Previous post was at 15:53 ----------
leo_o2 said:
What do you do with the L? For common source stage, the gain will depend on gm.ro. If you have same w and smaller L (though w/L is increased), gm will increase by a little while ro will be reduced more. And gm.ro might be smaller.
Click to expand...

Bro, what if i have the same L with 0.18 while i set my W=45 and 44, which one will have greater gain ?
 

If all other parameters are same, of cource bigger W will have bigger gain.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top