Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Is there any standard for SMD Inductors Pakcage? Any lib on eagle?

Status
Not open for further replies.
S

Sink0

Full Member level 6
Joined
Nov 25, 2009
Messages
390
Helped
37
Reputation
74
Reaction score
30
Trophy points
1,308
Location
Sao Paulo, Brazil
Activity points
4,186
Hi, i am working on eagle cad and i need to place a SMD inductor but i can't find any kind of information about the package other than the lenght of it in all directions. Is there any general group of packages for SMD inductors (like A, B, C... for Tantalum) or no? I am going to need to create my own footprint? Any lib for eagle with many inductors packages?

Thank you!
 

Search for and download the free IPC7351 viewer (now on the Mentor website) and this will enable you to enter the component dimensions.

Then it will give you all the dimensions needed to create the footprint yourself in whatever CAD package you use.
 
  • Like
Reactions: Sink0

    S

    Sink0

    Points: 2
    Helpful Answer Positive Rating
Use the rcl.lbr from Eagle. Inside you´ll find a folder named L-US with lots of inductor packages. Inductors come in many different packages ranging from the popular 0805, 0603, 1206,etc to A (=3216), B (=3528 ), etc and many other types. Please refer to the datasheet of your specific component to find the package that better fills in.
Best regards
 

IPC7351 viewer is not being a good help becouse the datasheet itself does not give much infromation about the inductors sizes.Take a look at these 2 dataheet and see if can get any kind of useful information of it:

**broken link removed**
**broken link removed**

Thank you!
 

Inside the rcl.lbr find the folder L-US and select the package L-USWE-TPC. It seems to fit the CDRH5D18 specs.
 

Yoe are correct, the IPC viewer is not going to be much help.

Because you do not need it - the pad dimensions are on the datasheet.

What about them is stopping you making a footprint?
 

pauloynski said:
Inside the rcl.lbr find the folder L-US and select the package L-USWE-TPC. It seems to fit the CDRH5D18 specs.
Click to expand...

Thank you.. i am going to take a look on that. OFFTOPIC: Where are you from Brazil.. its rare to find more pople from brazil here ate EDA.


Mattylad:
Al the times i tryed to make the pad myself i did not have a good result. Well i am going to try it again. But i could not identify wht is the PAD at CR54 datasheet.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top