Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

low frequency circuit and use of capacitor

Status
Not open for further replies.

npham9

Newbie level 2
Joined
Apr 9, 2010
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
virginia
Activity points
1,294
Hi all,
I am building a ECG circuit, and I've read some discussions on this forum. I have a question: In a book on reducing noise, one says for low frequency we should use electrolytic capacitors and limit resistor values due to temp noise. We can use parallel and series grounding to minimize noise. Is it true? (on the forum the advice is that no electrolytic capacitors is used because of tolerance).
 

npham can u clear wat sort of noise r u filtering ??? ...i can help u only if u provide the signal u required n the noise to be filter

ap123
 

    npham9

    Points: 2
    Helpful Answer Positive Rating
Thank you , I've just asked , I wonder why we should use different capacitors for different circuits. Are they different?
 

Different types of capacitors have different characteristics so they are used in different circuits. Electrolytic capacitors have a poor accuracy, high leakage and are polarised. But the have high values. So you would use them when you need a high value and don't mind about the other characteristics so much.

For filters, you usually want high accuracy and non-polarised so would pick a different type. In the past that might have been polypropylene or polyester but nowadays there are very good ceramic capacitors around, so they can be used.

Keith.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top