Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HP3048 phase noise software help?

Status
Not open for further replies.
B

biff44

Advanced Member level 6
Joined
Dec 24, 2004
Messages
5,047
Helped
1,376
Reputation
2,748
Reaction score
1,056
Trophy points
1,393
Location
New England, USA
Activity points
37,908
hp3048 software

HP3048A phase noise test set from Hewlett Packard. I have all the hardware to make up a system, but I am missing the following:
Controller
HPIB card
Windows based software.

If you have access to one of these, could you please report on:
what computer model/make it is running on?
what version of microsoft windows (windows 95?)
what the part number on the HPIB card is?
Is it a windows or DOS program running?

If you have access to the measurement software, could you please make a copy and send it to me.

Thanks very much.
Rich
 
Last edited by a moderator:

hp3048a software

Somebody can at least someone tell me the HPIB interface board part number?
 

phase noise software

Hi,

You can have a look at these interface cards from Agilent technologies

# 82350B PCI High-Performance GPIB Interface Card
# 82351A PCIe™-GPIB Interface Card

you can go for agilent VEE software, which can control all GPIB based instruments.

Added after 2 minutes:

Its a windows based software,no special requirement for PC,any
general purpose PC can run these programs.
 

    B

    biff44

    Points: 2
    Helpful Answer Positive Rating
RE: software for the HP3048A Phase Noise measurement system.

Thanks, guys. Thru a PM I also found this site, containing software downloads and manuals for the HP3048A. Do not know yet if they will work, but I will try soon.

https://www.febo.com/pipermail/time-nuts/2009-March/036735.html

I am actually very excited. I am close to turning a boat anchor into a very useful piece of gear!

Rich
 
Last edited by a moderator:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top