Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HSPICE is printing all nodes's voltage

Status
Not open for further replies.
M

mike_bihan

Full Member level 3
Joined
Mar 21, 2002
Messages
182
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
1,531
Hi:

I can't remember how to let hspice just print out the specified nodes' voltage.

I tried .option probe but it seems not working. It still dumps all nodes's waveform into the tr0 file.

Please help on this, thanks.

Added after 29 minutes:

I found it it caused by .probe v(*).

HSPICE probe all levels signals with this wildcard option. Any way to print only first level signals?
 

either write individual node names in the probe statement or in the option staement write postlvl=n where n is level of heirarchy you need to go down...

just cross check if its runlvl instead of postlvl
 
  • Like
Reactions: kaisin

    K

    kaisin

    Points: 2
    Helpful Answer Positive Rating
Yes its "postlvl" and "posttop"... not runlvl.

just use these two in option statement and uwill get the desired reults...

hope this helps!
 
  • Like
Reactions: kaisin

    K

    kaisin

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top