Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to set Siemens C7-634 into transfer mode?

Status
Not open for further replies.
siavashhn

siavashhn

Junior Member level 1
Joined
Aug 29, 2007
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,372
Does anybody know, How should I put a siemens C7-634 op, into Transfer mode?!?!?!? :?:

I used UP+ESC for C7-633. But for C7-634 I can not do this.
Thanks in advance
 

op c7

I think my ESC button is damaged , beacuse when i press it, no bit in System-key DBW is changed.
 

siemens c7-633

i need help ,
i want to connect plc log with a load cell to its analog mode. the load cell is giving the voltage in mili volts. what should i do ?
thanks in advance
 

siemens c7 french

First of all what is your PLC brand and what do you mean by "plc log " ?
 

transfer mod pro c7-633

C7-634 has high volatage (10 V) analog input only and isn't suited for direct connection of a load cell.
 

c7 634 op

of course there is some module to amplify and linearize the mv of your Loadcell to 0-10V or maybe 4-20mA.just find the module and buy it.For Example for a pt100 I bought a transducer which did all the zero and spaning things.... Good luck

P.S: You should be abale to find schematics for this transducer all over the web. just take a look
 

siemens siemens c7 633

Hi!
Right+Down+Esc= Hold and switchON = Delete Configuration & Set Password Default (100)
This will put C7 in transfer mode,but you must see if you want to delete configuration.

Best regards!
Venix

Added after 8 minutes:

Or you can try ESC+UP (during startup) for direct serial connection.

Best regards !
Venix
 

    siavashhn

    siavashhn

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top