Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

I Q Signal layout skill

Status
Not open for further replies.
M

MW+RF=Netpig

Banned
Joined
Jun 23, 2006
Messages
11
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Activity points
0
I only kown that the I Q singnal need the same width and the same length when PCB layout ,but I still don't konw the best width and space between I Q Singal ?
Does anybody who can give me some ideas?
many thanks !!!
 

IQ signal shall be ground protected.
IQ signal can be 4mil width with 4 or 8 mil spacing in between
IQ signal shall be at least 8 mil away from other signals and 4mil minimum
distance to enclosure ground.

8PSK modulation IQ would be much concerned and sensitive to layout defect
than GMSK modulation
 
Check the tranceiver's differential input impedance,
then you can use tool(like POLAR) to calculate the width and space between I Q base on your PCB stack up.
Please keep the width wider (at least 4mil) for PCB varation and impedance control.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top