Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, Wingji: If you use the 50-ohm normalized ports (all port schemes except the EXTENSION FOR WAVES scheme), the IE3D solved s-parameters are always normalized to 50-ohms in the output files. MODUA will be invoked automatically to display the s-parameters output files for you. If you want to display other than 50-ohm s-parameters, while MODUA is displaying the s-parameters, please choose CONTROL->TERMINATING IMPEDANCE to change the Zc of each port. The displayed s-parameters will be normalized to the Zc's you define. It is convenient for simulations.
You can also optimize the s-parameters, radiation patterns etc. with the ports normalized to non-50 ohms. To change Zc's, you can select Excitaiton and Termiantion in the OPTIMIZAITON SETUP dialog. Some users may not notice they can select pattern parameters such as gain, directivity, efficiency as optimization goals. It is due to the fact that those parameters will not appear in the list unless you select PATTERN CALCULATION before you select ADD OPTIMIZATION OBJECTIVES.
It seems the "Modua"->"Terminating Impedance" can only be changed in "S parameters" mode, in order to see the VSWR change, I need to change Impedance in "S parameter" such as "dB and Phase of S", and then switch to VSWR mode.
And also, when display more than one SP file with "Parameter File Queue", it seems the additional traces cannot be normalized to the new port characteristic impedance at the same time.
However, it is not a big deal for these little problem. Thanks for your help again.
The feature "Terminating Impedance" has been an old one and the "VSWR" is newer. We might forget to enable the "Terminating Impedance" in the "VSWR" mode. We will enable it. It should be in the next release. Thank you for the feed-back.
To change the Zc's of the file in the display queue, you should change in inside the display queue dialog. It might be a good idea to also implement a button in "Terminating Impedance" for you to change the Zc of the queue files. It may help users on it. Thanks!
Best regards,
Added after 1 minutes:
Hi, Plasma: We will make more avi files to show users how to use IE3D more efficiently. IE3D is full of features. I understand that many of those features are not used by many users because they don't know it. Yes, the best way to help users to create some avi files for it. Thank you very much.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.