Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Reverse current protection not needed in synchronous rectifiers?

Status
Not open for further replies.
C

cupoftea

Advanced Member level 5
Joined
Jun 13, 2021
Messages
2,664
Helped
54
Reputation
108
Reaction score
116
Trophy points
63
Activity points
14,008
Hi,
We are doing synchronous pushpull 300w, 24vin, 32vout, 153khz txformer frequency.
We use the LTC3901 synch rect driver. It has reverse current protection. But is there any point in using it? The attached LTspice simulation shows its not needed. When you go into no_load….the output inductor current just oscillates harmlessly back and forth. (LTspice sim and jpeg attached)

LTC3901

LTC3723
 

Attachments

  • pupull300w_syncrects_fm.zip
    3.8 KB · Views: 97
  • Synch rects.pdf
    115.5 KB · Views: 97

Sort by date Sort by votes
The circulating current results in higher losses when the load is very small. Also tends to increase EMI as well. I believe that's the main motivation for synchronous converters sometimes having a "forced DCM" behavior.

Also preventing reverse current is sometimes desirable when the load can actually source significant power, for example in battery chargers.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top