Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] What happens if Internal OpAmp is used ?

Status
Not open for further replies.
O

Okada

Banned
Joined
Jun 16, 2016
Messages
1,159
Helped
129
Reputation
252
Reaction score
129
Trophy points
63
Activity points
0
I am using PIC16F1708. I am using PORTC except LATC2 for 7 Segment Display. I am also using Internal OpAmp whose output pin is RC2. If I use OpAmp and then if I write something to LATC2 what will be the output at pin RC2 ? LATC2 value or OpAmp out value ?
 

Usually the peripheral takes control of the pin. But in this case the datasheet is very clear. Look at page 232 of this document: https://ww1.microchip.com/downloads/en/DeviceDoc/40001715D.pdf

opamp.PNG
 
  • Like
Reactions: Okada

    O

    Okada

    Points: 2
    Helpful Answer Positive Rating
Thank you very much. My problem got solved.

Attached image shows the project working. Op Amp is working fine.
 

Attachments

  • Load Cell Measurement.png
    Load Cell Measurement.png
    55.8 KB · Views: 123
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top