Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] minimum signal strength for sending sms

Status
Not open for further replies.

bikashh

Full Member level 5
Joined
Nov 28, 2009
Messages
264
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Location
india
Activity points
3,132
Hello Friends,
I am doing a GSM based project and using M10 GSm module for sending & receiving sms, I want to know what is the minimum signal strength for sending/receiving sms. when I send "AT+CSQ" command to the module ....it returns

+CSQ: 10,0

OK

As you can see that the signal strength is 10. So is it a good strength or worst

Thanks
 

Value:

+CSQ: 10,0

is low signal level, and represent lower limit of signal strength, best is to have 30 (53dBm) or more.

Higher number is better, number below 10 is bad.

Check device spec and manual, also try other locations for usage.

:wink:
 
I feel that this signal strength(10) is ok for sending and receiving sms.
 
I also have another doubt, when I am sending sms I wait for '>' after issueing AT+CMGS command. if within 3 sec I don't receive this symbol I issue <ctl+z> but the module give +CMS ERROR: 3765(which means invalid input), what should I do in this case. should I restart the module as the module goes into hang mode.

Also,is this 3 mins Ok to check response
Thanks
 
Last edited:
I feel that this signal strength(10) is ok for sending and receiving sms.

Were you able to figure the minimum amount of dbs required to send an SMS?

thanks!
 

Min signal strength req to send sms is 15.

thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top