Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: [HELP] P*cad2002
hi Bobcat:
see the attached figures
fig1: draw the circuit.
fig2:select the circuit you have to clone and copy it (ctrl+c).
fig3:paste with the paste circuit option.
fig4:specify if you want the refdes normally incremented (r1,r2-->r2,3) or by prefix (r1,r2-->r101,102)...
Re: [HELP] P*cad2002
Hi Bobcat,
you have simply to use the copy funtion as usual,but paste with the paste circuit option,paying attention to specify if you want the refdes incremented with prefix or not(r1-->r101-->201), and which net names will follows the same rule:(gnd-->gnd1)
Copper pours...
ad825 audio
Hi hot_chmock
audio preamp for what? and why AD825?
Audio preamp is not "one size fits all" circuit :
low-z mics (50-200 ohms) preamp are quite different from line or hi-z mics, so, to optimize noise ,frequency response performances etc ,you need to match at least what different...
ground noise
Hi Rostfrei,
the simplest solution is to break the existing gnd loop (some of your connected devices have more gnd return paths,and could be due also by the antenna amplifier power supply, that is normally fed thru the antenna cable), by inserting a 1:1 600ohm audio xformer in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
