Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
am making a small cnc for my lab.however i would like to use a pic16f88 to controller a 5 wire unipolar motor that uses 12 volts. I would like to use KCAM software to control the stepping motor. I have written some assembler code using MPLAB.When i simulate the code in the simulator in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
