Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I use dspic30f4013 with C30 compiler, and I want to use uart at low baud rate (5 baud). I cant configure uart at that speed because fosc is too high (22.1184Mhz). How can i divide clk frequency with postscaler? Is there some macro for that? Or i just have to set bits some bits in OSCCON...
I dont want to open new thread so I will ask here for my problem.
When I set scale on 1, my print is smaller than it should be. I dont know why. With couple of tries I have established that good print is on scale 1.01, and corrections for x (and y) are also on 1.01. Can anyone tell me why is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
