Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The most difficult part is the pc board. Sparkfun has a smd to DIP daughter board that makes it easier. Havent got enought points to dl your file. What ir remote protocol did you use ? My goal was to use the Dishnetwork remote(RC5) which controls all my other A/V stuff.
Thats not too bad at all...
The following code runs fine when the value of bite is set inside the sub procedure
I2C_send_byte. But when set prior to calling the sub, sda does not change when the code runs in the sub. And scl changes properly inside and outside the sub. Of the two ways of writing the IF line neither one...
tektronix+pc oscilloscopes
I had a link
was talking to warren at the company that makes it. sounded good,Ill find and post it.
heres the link:**broken link removed**
its about 1/3 -1/2 the cost of others ive looked at.
Lemme know that you think. Ive deceided to keep my old analog TEK for a while
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.