Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks u frank , I read in many articles that the CB configuration can be the best one but really I don't see why.
U chose the CE , you have right that the common emitter provides the highest loop gain , but we don't need a highest one , only we need is a loop gain greater than one in order to...
Which configuration can be used for wideband VCO design?
common base ,common emitter or commn collector.
can you give me any example of calculs.
thanks
I use the HB simulator to simulate the steady state of oscillator, when I activated the noise simulation, I Have HB.freq and HB.noisefreq, I know that I can use only freq in weighting factor.
I want also to simulate the phase noise so I implement the Low-Frequency noise sources in the transistor...
Thanks for your reply.
I have I_Noise=Kf*I(t)^Af/(1+freqnoise^Af)
and I(t)=Idc+Iac
so I can't use directly the I_noiseBD, because the Ie is for dc current only
RF and MW swithces?
I wanna ask you if there are a possibility to design a swithces based on HBT ?
Else could you plz give an introduction to RF and MW swithces design and theory .
10x
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.