Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by zdenko

  1. Z

    Can I use software for Pic16c84 with Pic16f84?

    Re: Pic16f84 sw Is it possible that noone know this.
  2. Z

    Can I use software for Pic16c84 with Pic16f84?

    Can I use sw of Pic16c84 for Pic16f84. Thank you!
  3. Z

    Help me identify ROM 6330 IC from this schematic

    Re: LIght scoroll Thank you!
  4. Z

    Help me identify ROM 6330 IC from this schematic

    Do you know which IC is ROM 6330. Or do you know for similar project. Thank you.
  5. Z

    AT90s8515 assembler syntax

    Thanks!
  6. Z

    AT90s8515 assembler syntax

    Please where can I find assembler syntax for AT90s8515. This is simple programm below.But I want to know what meanss interpunction characters ( . , : ; ) etc. Some lines was draged /like **rjmp RESET** / some not. Some lines was interspaced ,some one line ,some two...
  7. Z

    One neon tube how to change color

    Yes this is my mistake.But this is possible if you read tutorial Bhosle_1 above.
  8. Z

    One neon tube how to change color

    On this page I found equipment for changing color of the neon tube. www.multineon.com
  9. Z

    One neon tube how to change color

    Thank you!
  10. Z

    One neon tube how to change color

    I found one tutorial but it hard to understand to me. Here is this tutorial:
  11. Z

    One neon tube how to change color

    How can I change color of one noen tube from rod to green etc. I am shure that is possible but I dont know how , with frequnecy or or diferent curent /high or low voltage/.
  12. Z

    STI5518 jtango break point

    I mean brakpoint addresses BPadL amd BPadH not Break trap handler address.
  13. Z

    STI5518 jtango break point

    I want to see a b c registers at brakpiont , and if you know tell me please how can I find breakpoints addresses to write in the Jtango breakpoint analyser?
  14. Z

    STI5518 jtango break point

    How can I find break point. I have flash dump and RAM dump. Thank you.
  15. Z

    STI5518 jtango break point

    jtango I try to work with JTANGO break piont analyser , but I can't do it. I have two questions about it: - I know Iptr address must be between BPAddL and BPAddH , but where are BPAddL and BPAddh placed in the RAM or flash ROM. - Defult Break trap handler address is between 401FFF30 and...
See more

Part and Inventory Search

Back
Top