Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
why current drawn by stepper motor doesnt increase when load is applied on motor?
Hi all,
I am working with a ST-Nucleo board and L6470H Eval board to control a stepper motor(QSH4218-51-10-049). Using the SPIN evaluation software I gave the values for Holding current, Target current etc. But...
Current doesnt increase with an increase of load on the Stepper motor ?
Hi all,
I am working with a Nucleo and L6470H Eval board to control a stepper motor. Using the SPIN evaluation software I gave the values for Holding current, Target current etc. But when I run the motor, the motor is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
