Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks philoman.
For example, when using MUSIC algo, it is required the steering vector and the impinging signals vector.
In the steering vector it is needed an angle...which angle is this?
Hi all.
The MUSIC and ESPRIT algorithms are supposed to estimate the AOA of a signal. I would like to know which information I need in order to estimate the AOA. I think the only information that is needed is the signal and the elevation angle but I would like you to confirm this.
Another...
Hi all.
I have already done a simulation of an adaptive beamforming for a linear array. I used a simple adaptive algorithm(LMS) to update the complex weights of the antennas, but i was supposed to input the angles of arrival of the desired signal and also the angle of arrival of the interferers...
equalizer matlab
Hi all.
I want to program an equalizer in MATLAB. I've found that central frequencies por band-pass filters must be 31,63,15,250,500...... but i can't find the bandwith for each band pass filter, can anyone please help me?
Thanks
pic usb flash
Hi all, i need your help for developing this project.
I want to read/write data from a usb flash memory using a pic but i have some questions.
Can I read/write data from a usb flash memory just using a PIC or it is impossible without installing a fat16/fat32 into the PIC (I...
how to program pic32
Hi KST, thanks for your help.
The schematic you have posted is for buildin a development board, right?
And how do you program the pic32??
pic32 starter kit
Hi.
I would like to know if someone have already designed a board to use the hirose connector of the PIC32Starter Kit in order to use the peripheral devices.
If you have devolped one, please post it here.
Thanks
j2se and bluetooth
Hi all.
I wish i can explain myself well, since i'm not good at english.
Mmmm, let explain you the project.
From a pc with bluetooth(usb-dongle) i want to send orders to a cellphone(with bluetooth) that is on a car. A microcontroller may get the orders from the cellphone...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
