Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello again.
this is my progress so far,
Can i share my project file here? should I?
Thanks in advance
- - - Updated - - -
Finaly ! :O Any observations?
So far i keep failing, the last pic i shared didn't work out so well so i started all over again.
had difficulties to get the GND all over the board, too much cross routes....
the placement of components indeed.
Can any1 help me with this? getting tired :bang:
Hello everyone,
So this is my project :
I'm a new eagle user and am kinda stuck at the routing level.
I would like to use 1mm width. at 45°(wire bend style)
IC1 is 7812
IC2 is TPA3122D2.
Not sure how to use the auto-router option and honestly i prefer doing it manually.
Finally any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
