Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
[merged] m90e26 enery meter calibration
Hi
i have problem with some calibration parameters in m90e26 aplication note,there is a epsilon(ε) in page 12 that i can't understant how i calculate it!!!
it is the sentence--->[Assume the error output from the calibration bench is ε, then]
another one...
Hi
i'm working with m90e26 and i did calibration (ugain&igain) but the m90e26 does not show correct values and iam sure that there is no problem with spi interface.
is it possible the atmel ic being out of repair although it shows frequency correctly??
help please :bang::bang:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
