Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm not sure freeze mist would do the trick here.
I was able to reproduce it quite easy, I opened up the back part of it and turned it on, waited about an hour and then turned it off.
once I tried to turn it on it, the LCD light doesn't come on, it start the power on procedure (raise up noise)...
I did replaced the capacitor and it didn't helped very much, when I refer to the issue I mean by that the image is freezed with irregular lines across the screen, at that point shutting it down and trying to boot it back up won't succeed.
There is a BGA package I will now upload pics of the boards.
Hi, unplugging it from the power input.
after each time I've disconnected the boards it worked for a day, on the next day it started doing problems again.
Hi all,
Recently my LG 32' LCD TV is doing a bit of problems, it started by during run time the image is freezes and then continued to it won't start at all, the red led below is blinking and it won't start.
at first I thought it was due to bad caps (as read online), but they seemed fine and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.