Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I am trying to build a circuit involving a XBee 868LP device. However, i can't find the correct socket for the device. The XBee is attached to the board using some kind of flexible header pins which "locks" the device in place after you push it into the socket.
Anyone know what these...
Thank you for your reply! What is the best way to address the problem of common impedance? The distance between the circuits and the ground will be very short, probably between 5-10cm of copper trace, since the circuit will be on a PCB. Will this have any effect?
Thanks again,
Ole K.
Hello,
I am currently working on a project where i want to be able to turn on and off the power to three circuits from a microcontroller/button switch. These are low power circuits where the total current wont exceed 600mA. Is it possible to do this with a transistor as shown in this picture...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.