Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello a newbie here.
I'm currently doing the same project as the OP but using a different microcontroller (PIC18F4520). My question is if the TX pin (RC6) is being used for the transmission and the RX pin (RC7) is being used for the reception for both PIC, if the RS232 is connected to the PIC 2...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
