Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I tried to make Cuk Converter butt it is not working properly it is not energizing load more than 1.5 Amp butt my load is of 5 amp's and I think there is problem in choosing the value of Input and output Inductors so plz some one help me....
I think if you r going with microcontroller then you don't need any ir sensor you just use voltage divider for voltage measurements and use shunt resister for current measurement and do mathematical procedure using PIC microcontroller and the best PIC for this purpose is PIC18f452 as I have used...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
