Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
If a parameter "i" defined in verilog code, but not evaluated, how to call the value outside the code, in SHELL?
Thanks.
code
-------
module any();
define i; //
...
...
...
endmodule
SHELL
-------
set i=$var
Thanks for your time, problem solved.
As a matter of fact, PDIO means P+/NWELL diode, one of the pop diode implementaion in CMOS process. Fvm, you are right, the unfinished parameter setup of diode cause the result to be wrongly full wave.
hi all,
I try to simulate the classic half wave rectifier circuit with one resistor and one diode by HSPICE, but the result shows voutfollows vin, i.e. there is no effect of the diode switch function during the vd variation. What i am confused and also want to know is whether HSPICE can properly...
hi,
Many character or digital symbols, such as "150a", appear inside the chips layout. They offen seems to locate at four corners, using full range of layers from diffusion one to top metal one. What is that used for?
Plus it is not the one for the company logo.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.