Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
I'm newbie with PIC.
I would like to read 12.5 kHz square wave frequency from printer port output. This 12.5 kHz square wave have to be read by PIC16F877A. If 12.5 kHz is read, then PIC's output will be High. If 12.5 kHz isn't read, the output will be Low.
Can anyone suggest me how to...
Hi everybody,
Firstly I would like to say Hi to everyone.
I have some questions about solar panel.
I would like to know how solar cell and module work.
And how do these solar cells have been made?
Can you help me, show me? Please.
Thank in advanced
Best Regards
xylynn
servo motor control
Dear Brothers,
I would like to control DC servo motor with PIC16F877A. It's no matter whether PIC16F877 or not. I just want to get the idea from this.
And also what is the most important thing in Servo motor? It's very good for me if you share me the circuit...
remote working system
Dear all,
I would liket to know what is remote working system and what equipments I need for implementing this system.
Best regards,
xylynn
Dear Sir,
I've already draw the circuit diagram with Proteus. But I don't know how to generate PCB disign. Please kindly give me some suggestion.
Thank you
Best Regards,
xylynn
t0cki
I configure all the 16F877A pins for digital I/O. adcon1, cmcon and lvp_off.
But I still cannot use RA4 as digital. Why? I think T0CKI affect is on this pin. How to turn off T0CKI?
Thank you
Best Regards
configuration of pic16f877a
Dear Sir,
I would like to do some projects. I first intended to use 16F84A. But later I found that it don't have enough I/O pins. So I change to 16F877A. But unfortunately there is a lot of configurations for 16F877A for I/O ports. First I would like to use...
configure +adcon0 +pic16f877a
Yes, you are right..
I will try what you tell me.... I forget about the pull up resistors....:idea::idea:
Thanks a lot for helping me....
Best Regards
xylynn
set pull-up portb 16f877
Where can I find the programmer circuit board and related software for PIC16F877A??
Thanks all... brothers...
Best Regards
Lynn
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.