Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
This issue is found when I test Vcc range.
Vcc=2.7v, pull up resistance=100KΩ, product will stop work; But when change pull up resistance into 20KΩ,product start to work again. change pull up resistance into 100KΩ, product stop work again.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.