Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by Woomos

  1. W

    [DCT] What parameters can be tuned in the DCT for performance ?

    Thank you for answer. But I I made the mistake of not writing down DCT's full name. It is Design Compiler Topographical (DCT) mode. I'm really sorry and thank you for your time.
  2. W

    [DCT] What parameters can be tuned in the DCT for performance ?

    Hi, I am currently studying DCT, and I am curious about what parameters can be tuned in DCT for performance, unlike DC. I'd be grateful if you let me know anything that comes to mind. Thank you.
  3. W

    Question about VIA overhang.

    Hi, I had a question about VIA overhang while I was studying. I know that VIA overhang is a parameter that is set to improve the yield of VIA. When drilling VIA in the process, it makes sense to apply an overhang to the upper layer because the shape of the VIA becomes trapezoidal. However, I...
  4. W

    How to mark layer comments in CAP of spef file using StarRC

    Hello, I'm Orati. I also found CAPACITOR_TAIL_COMMENTS but I am getting this error. The CAPACITOR_TAIL_COMMENTS:YES command is only available in Caliber-StarRC or ICV-StarRC flows (SX-3587). I am trying to extract the layer information of the CAP using only Star-RC without using Caliber. Is...
  5. W

    How to mark layer comments in CAP of spef file using StarRC

    Hello, ThisIsNotSam. My purpose is to comment out the CAP's layer like "$lvl=3" in the RES. In the case of RES, when extracting the .spef file from the Star RC tool, it was possible to comment out the command. But I couldn't find a command for the CAP case. Currently, I use tcl to directly...
  6. W

    How to mark layer comments in CAP of spef file using StarRC

    hello. I got the spef file as in the example below. The tool used is StarRC, and I found out the layers of RES through the command below. NETLIST_TAIL_COMMENTS: YES However, I also need information from the CAP layers. Is there a way to mark the CAP layer like RES in StarRC?
See more

Part and Inventory Search

Back
Top