Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi...
I m working on CAN project. I have already brought AT90CAN32 chip. Now the set up is ready. I m using the PONYPROG software on ISP programmer. I m able to write into the chip only if i select the chip as AT90CAN64. It looks like watchdog timer is resetting just after it configures the...
Hello ,
I currently started with AVR.. (AT90CAN32 chip by atmel)
I hooked up all the pins required for SPI programming using Ponyprog V2.07c Beta software
MISO - pin 3
MOSI - Pin 2
RESET - pin 20
SCK - pin 11
as well as VCC and ground .
I have connected 12 Mhz...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.