Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
A port with 50 Ohm resistance can be used as the input noise source, attach it to the input of your circuit, that's all you needed to do in the schematic level,
then choose .noise analysis in the design environment,
set the frequency range you are interested,
and in the "output noise"...
Hi, recently,I am trying to use FDTD to simulated surface plasmon, after seting total field/scattered field for TE (Ex,Ey,Hz)model,I don't know how to introduce a finite width plane wave in the total field region. After the ordinary procedure to generate a plane wave at the vitural interface...
May be 150nm thick metal is large than the plasmon decay deepness, I want to simulate the surface plasmon too, may I ask you some question about how to simulate the surface plamon?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.