Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Anyone have experience interfacing this two parts ?
Please give me some example of commonly used vibration sensor that available in market.
I was going to install it on my mobile robot so i can monitor when robot was going up/down slope .
thank you
ultrasonic distance meter + atmel
Hi ,
I am currently doing research for my final year project. Part of my project need me to construct a ultrasonic sensor . Most common available ultrasonic sensor is from PARALLAX PING.
Did anyone have experience programming this kind of sensor with...
atmel 89c8252 isp programmer circuit diagram
u might want to try this : ht*p://www.kmitl.ac.th/%7Ekswichit/IspPgm30a/ISP-Pgm30a.html
i surveyed few websites and this one seems quite ok . Please do send me a personal reply email if u had try out this circuit .
Thank you
My Email...
i was given an inverting amplifier has R1=20kΩ and RF = 600kΩ. The op-amp parameters are A0 = 2x105, fO =10Hz, RO=100Ω, and Ri =2MΩ. The frequency of the input signal is fs=10 kHz.
Determine the unity gain bandwidth fbw, the closed loop voltage gain Af and the closed loop break frequency...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
