Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i'm are new in mcu. i have experien in same case . my cicuit use PIC mcu drive magnetic coil. after drive magnetic mcu will reset.
i try use optocouple drive transistor power my circuit can work good in my idear. you try use this for solve.
i hope this you help.
hi everybody.
i can't sure i post true web board?
i want convert physic value (voltage curruent or '....) to a constance for send to variable in program computer.\
how to start idea and i can serch data form where?
thank you.
help to check my setting this true.?
XT 4 MHz
i connet serire 10 k resistor between v 5vdc to RA5 ready.
and input use 5 vdc form supply by devider current by 10 k resistor to ground.
this still not work..help me please....
hi everybody after i pass first step
i test code for check input status
if input =1
delay 20 sec
and if input still =1
i want set out =1 and delay and stop out put again;
by code
main()
{
TRISA = 0x01;
while(1)
{
start:
while(PORTA.F0==1)
{...
hi everybody i new pic programing and you can help me.
first..
this my code by mikroc
void main()
{
TRISB=0b00000000;
while(1)
{
portb=0b00111111;
}
}
i already build this code to hex file
and Write to pic16f627a by topwin6 and topwin2007 programer
but this not work in circiut board \...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
