Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello, I have installed the orcad 16.3 version. Unfortunately, I'm missing orcad Layout plus in this bundle. What should I do? I'm ready with my designs in Orcad capture. Now I need footprints to put in each components properties.Can anybody help me out? I need some guidence how to install...
P.S. I'm working on a fresh install and the check-boxes to select components for placement are not there in the pull-down list.
Can someone please tell me what the problem maybe?
Thank You
Hello, I am trying to develop a board. I have done the schematic in Orcad CIS and created a netlist for the 3 .dat files and have no errors. I have also imported into Allegro and have no errors. But there are no symbols or rat nest on the .brd file I have loaded. From what I understand there...
But, how many times the skin depth is this minimum thickness?
---------- Post added at 23:18 ---------- Previous post was at 21:30 ----------
For the monopole, the ground plane will be placed on a particle detector, which detects the energy of the incident particle. Hence the thickness of the...
Hi everyone,
I'm working on a project to build a monopole antenna. To do this what should be the minimum thickness of the ground plane, so that the antenna radiation is not affected significantly?
Thanks and Regards,
way2nitinp
Hello everyone,
I'm new to HFSS. I'm trying to simulate a monopole antenna, with a coaxial feed in it. It works fine when just the antenna is simulated as the exitation port is on the Air box boundary. But once I integrate it with the external structure and surroundings, I had to shift the port...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.