Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by VVRuban

  1. V

    How to determine the minimum requirement for OP?

    Re: OP requirement Hi Maybe this Application Note from Texas Instruments be useful for you. You can find it... **broken link removed** and "Op Amp Noise Theory and Applications "... **broken link removed** .....and much more there http://www.ti.com/sc/docs/psheets/rel_msp.htm Best regards.
  2. V

    Where can I get detailed info about ground?

    Re: ground Hi Application Notes from Analog Devices ( Grounding for Low-and-High frequency Circuits )Know Your Ground and Signal Paths for Effective Designs. Current Flow Seeks Path of Least Impedance-Not Just Resistance...
  3. V

    Looking for materials about biomedical analog circuit design

    Re: Biomedical electronics Hi LIST of books about Biomedical DSP. h**p://www.dsprelated.com/books-1/hf/all/Biomedical_DSP.php Another book "Biomedical DSP. Tompkins" recently was in Uplo@d/Downlo@d forum. You must search while being inside forum. Also companies which produces biomedical...
  4. V

    How to avoid initial high current in switched capacitor?

    Re: initial high current Hi Maybe you can pay an attention on NTC( Negative Temperature Coefficient ) thermistor. These devices are widely used in ac-dc power supplies for initial current limiting. Best regards.
  5. V

    Wood Humidity measurements.

    Hi I want to measure wood humidity during the drying proccess. What method is recommended. I've heard about conductivity measurement of wood which depends on humidity ( mass contents of water in wood ). But for this methods calibration tables for each sort of wood needed. Can anybody recommend...
  6. V

    Very accurate low resistance measurement problem

    lock-in voltmeter resistance measure Hi Here is interesting APPNOTES from ADI about micro-OHM measurement. Maybe it will be useful for you. Best regards.
  7. V

    is this opamp available from any manufactures?

    Hi Try to find it on TI parametrical search www.ti.com I'm not sure but similar search exists on ADI site www.analog.com Best regards.
  8. V

    is this opamp available from any manufactures?

    Hi Try to find it on TI parametrical search www.ti.com I'm not sure but similar search exists on ADI site www.analog.com Best regards.
  9. V

    down converter from 10GHz to 100MHz

    Hello. Try this link on Zarlink dividers from DC to up to 13 GHz **broken link removed** Best regards.
  10. V

    What are the StateCharts and what are they used for?

    Re: What is StateCharts? Hello. In industrial automation exists PLC Programming language SFC ( Sequential Function Charts ). It had developed on base of Petri's nets. The language made as description of proccess states and transition between them. Maybe it will be usefull for you. Best regards.
See more

Part and Inventory Search

Back
Top