Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Feko Error 33110
Hello,
I have the same problem:' A triangle lies in the metallic ground plane'
I have to use ground to obtain exact result,but I couldn't solve the error,could you kindly help me?How can I solve this error,I am using FEKO 5.5 .
thanks a lot....
There are one source from the beginning point of the helix to the end of the helix,ı tried to make a toroid,and want to give a source to it,and analyze the impedance
I couldn't analyze with lumped port :(
hfss communication error
A rectangular can be used a face for a source I think,I tried to put a voltage source too,there were no error in validataion check but,I could't anayze.My circuit was only a one turn helix and at the end point of this helix there was a voltage source.It gives...
wire helix
I tried to do,what is needed for drawing a helix but HFSS gives an error such as : Body could not be created for part because of invalid parameters to cREATEhELİX operation.
I will be glad ,if you can say what can I do?
I am also a new user of HFSS,I want to draw a toroid,but I could't draw :cry:
Could you kindly help me?I draw a 1D or 2D object,and try to draw a helix,but could't do :(
please help me...
Added after 21 minutes:
HFSS gives an error such as : Body could not be created for part because of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
