Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
This is AV connector( RCA Jack).
Problem is height.
The top side of this around 13.2mm from the pcb.
My plastic model will be made of PLA or ABS material having 1.5mm thickness.
So, total height is 13.2+1.5=14.7mm from pcb.
My switch is having 14mm height from pcb.
So, should I...
Hi,
I am making new pcb library.
Is C1 and C2 are really necessary for pads design?
If I made square pads, then would it cause problem for reflow soldering?
Thanks
- - - Updated - - -
Hi,
Datasheet of XC6206 informs that output voltage can be selected(6th line, 1st page of datasheet). But how? There is no additional pin for select output.
https://www.torexsemi.com/file/xc6206/XC6206.pdf
Thanks
Hi,
I am working on project of electric fencing.
The main focus is pigs.
I found voltage should be 3kv+
But what about the charge and joule rating?
If ratings are 3kv and 0.5 joule then it will deliver 0.1mA current for second?
What frequency will be good?
And there should be feedback to...
Hi,
I made circuit. I need some suggestion for AGC. I made circuit with two opamp(ua741) one as gain amplifier and another as comparator. The O/P of comparator is directly driving mosfet(IRFZ44n) with 10k resistor on gate to source.
My speaker has two pcb circuits. One is audio receiver (sd...
Hi,
Hmm, ok my amplifiers are in case with speaker. It would difficult to open after arranging big stuff. Also it takes 4-5 hours for disassembly and reassembly. I will do in free time may be after 5 days.(adding 3rd amplifier) ;)
Thanks
- - - Updated - - -
Hi,
For AGC stage, uC is required...
Hi,
1) Yes I feel some distortion, power is felt low when I connect another amplifier.
2) Yes I should use clear words. speaker is having two meaning. The speaker manufacturer who creating speakers was also confused. When I asked Price list, he confused between multimedia speaker or transducer...
Hi,
Do you know any audio buffer IC ? Or I should make it with op amps? I need this because I am using already two speakers from single input by direct parallel connection. Sometimes I observe noise signals / insufficient power for my speakers as input signal is driving two speakers.
I will...
Hi,
Hmm what about three level of intensity? Is it includes negative value?
Thanks
- - - Updated - - -
Hi,
Should I care about negative peak? How negative music sounds like? Do sound of drum has negative to positive or vice versa? Or neutral to positive or neutral to negative?
If it has...
Hi,
I haven't Burnes out LED. I am planning to make led driver. My project is to make DJ light.
So there would be MOSFET in driving circuit.
I will amplify audio signal with opamp then will use comparator or uC to find peak and then will feed to the MOSFET.
MOSFET is rated with high current a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.