Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am a new learner.
I have built temperature and Humidity indicator using PIC 16F877a (LM35 +SH20).
I Have following two problems.
1) If I program to read only Temperature or only Humidity it shows correct.
But when I select Temperature + Humidity - Both shows erratic reading ( RA1 and RA2)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
