Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear Sir,
I have attached the schematic of the mobile charger. I want to increase the output from 5V to 12 Volts to drive LEDs in series.
Should I increase the zener voltage or change some resistor voltage. Please guide me.
I can also wound more turns in smps secondary if need arise or build...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.