Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: IE3D Cell Accuracy
Here is the geo file i was talking about. its gives quite different results when i used 20, 35, 50, 75, 100. Which one is accurate??
Re: IE3D Cell Accuracy
Thanks for replies, Well I increased meshing to λ/100 and it converged.
But I have some doubts, How do I decide on edge cells. Am using edge cell of 8.5%, and in the structure i have some slots of 10um and above width, so i can say the min resolution is 10um. Is there...
Hi all,
I faced this problem while designing strutures on a CPW line using IE3D. The manual claims that the accuracy of simulations will be very good if its about 20cells per wavelength. I started at 15cells/λ to 50. But with every simulation i was getting different results, S-parameters were...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
