Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ok sir...I have problem that any modification I did there were no change in results regardless of any change in physical geometry or change in material why it is happen so???
yes i have vaccum structure around for giving boundry.I had object intersection error.But I resolved it.how to solve port set up errors.I had given excitation at end of the absorber by putting vacuum sheet.thank you for your quick replies
GTEM cell is basically use for measuring radiation.Its pyramidal structure.length is 250 cm,width and height is 100 cm.inside it there are absorbers.absorber length is λ/2.where λ is operating frequency.i have used both frequency sweep linear and log scale in discrete form.my RAM is 3 GB.and...
I'm doing project on GTEM cell..I got error when i used fast sweep "poor conerges of seeding data" how to resolve it in my case.and also my simulation over without resuylts.1st I did simulation It produced result bu than no result at all...plz any one help me...
thank you sir,
but I don't know any thing about sub dividing or FEM or IE solver..so plz give me some guidence I didn't see any IE on start up..plz help me..i'm heavily thank ful to you..further I want to tell you that there is nooption for IE on start up screen is there other way to do it??
hello everyone
I'm doing simulation of GTEM cell using HFSS 11.I had crwated 4 different models of diiferent size and materials.when i simulate 1st model it simulated completely bu for other 2 models simulation completed without getting result.and for the last simulation error came "hf3d error...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
