Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
cmos vlsi design by david harris
Hello everybody.
I am not able to buy that book in my country and doing it by internet is way too expensive for me, I hope someone uploads the book someday.
I attach the solutions manual in case you need it :)
Re: How to install Alliance
Does anybody use Alliance for VLSI designs?
http://www-asim.lip6.fr/pub/alliance/distribution/5.0/
I have tried following the installation instructions included but without success.
Could you please tell me how the installation process is?
How to install Alliance
Hello.
I have been training with Microwind for a long time and now I would like to move to Alliance CAD software.
I do not have much knowloadge about Ubuntu so it has been difficult for me to install it there.
Could you please tell me the steps to install it properly...
Unfortunately I do not think I should spend more money now, as I am not an expert in FPGA's, besides you do not get money from trees :D, so I will go for the NEXYS2 board.
Thanks a lot for your help.
Thanks for your post hrhgroup
I am running out of time to buy one, yeah I think it is a very good board too, just wanted to know if someody had problems with it and/or recommend another one.
How many days did it took to get the board in your house?
Greetings
You are right echo47, I do not have specific requierements but I would like the best cost-performance relationship. That is why I have the NEXYS board as reference, because a friend recommended me that one.
Do you think it is a good one? Do you know other one with similar capabilities and lower...
Thanks for your post
That is why I ask for suggestions, I do not want a very basic board, but not an industrial one, I would like one whic suits for educational and prototypes.
For example, something better than this...
nexys2 de1
Hello everybody
I would like to buy a FPGA board, a friend recommended me ones from Digilen (NEXYS) but I would like to know your opinions.
Which is the best I can get for less than $150?
Thanks for your help.
spice schematic cadance
You are right LvW, Electronics Workbench is able to do that, so should be Multisim I guess.
I asked about Orcad Capture because I think Orcad Pspice A/D is good to simulate at high frecuencies. (In order to get the maximum operation frecuency)
Thanks for the suggestions...
.cir file
Hello everybody
I think it should be possible to get an schematic from a circuit description file, do you know the way to do this usin Orcad Capture 9.1?
------------------------------------------------------------------------------------------------
INVERTER TRY
V1 1 0 PULSE (0 5...
analog basics
I may suggest "Microelectronics" by Sedra/Smith book to understand most of the topics, it is a very good book, then you can use "Integrated circuit" by Jacob Milman, those 2 books should be enough, I tell this from experience :D
Links to Sedra/Smith book:
**broken link removed**...
Re: stupid question?????!!!!
I do not think it is a stupid question.
It is clear that you want a less abstract answer, but remember that the concept of electron comes from experiments, the same for positive and negative charges, they were discovered based on experience.
I do not have the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
