Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Sini
Thank you for your Info. I think the best way is to design bridge rectifier circuit with npn and pnp transistor connected to zero crossing pin. What is your advise
much appreciated?.
Thanks
Varooshan
Here is The schematic circuit https://obrazki.elektroda.pl/57_1289697507.jpg
Thanks
varooshan
---------- Post added at 02:22 ---------- Previous post was at 02:16 ----------
https://obrazki.elektroda.pl/57_1289697507.jpg
Re: Corrupted Sine wave on zero crossing
Thanks Brian
my problem is corrupted 50Hz sine wave is superimposed with harmonic of 5th order and pic 16f87 cannot find the zero crossing. where to connect the low pass filter before zero crossing pin?
at the moment there is a 220k resistor from...
Corrupted Sine wave on zero crossing
:? searching for an easy and efficient circuit to clean up corrupted sine wave 240Vac 50Hz. Pic 16f87 cannot find the zero crossing.
any help from you guys will be much appreciated
thanks
varooshan
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.