Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I'm unable to generate the terminal solution report for our patch antenna design in HFSS. Can anyone give the method of doing it?
We are using a lumped port for our design.
Hi,
In the case of fabricating an antenna I found that every fabricator uses FR4 only as the substrate material(generally for low cost fabrication)
My question is that, why do they not use PTFE which has a lesser dielectric constant?
Please help!
Thank you.
Hi,
We designed a microstrip patch antenna using HFSS having the following parameters shown in fig.
In this fig, when the inset distance is varied slightly ie even by 0.001mm also, the impedance decreases drastically.
This could be pretty dangerous when manufacturing the antenna is in question...
Distance of microstrip patch from the ends of the substrate while designing
Hi!
Can anyone please tell the criteria for the distance between the microstrip patch and the ends of the substrate to satisfy the resonant frequency of 2.4GHz?
In the image given, please indicate the rule or formula...
I got the formula for calculating the width of printed transmission line when I stumbled upon a book called "Antenna Engineering Handbook" by Volakis
Thank you again.:smile:
Thanks a lot.
It was very helpful.
But I find that there is no solid formula for the feed line width.
Even in the documents u provided links for.
Thank you again! :smile:
Thank you.
If it's not too much trouble for you, can u send me a few links to IEEE papers as I could not find any.
And u have directly given the values as calculated by Ansoft HFSS ADK.
But I need the formulae/rule to theoretically calculate it.
Hi,
Could anyone give the formula to calculate the feed width and length of an inset fed microstrip patch antenna?
The design is being done using HFSS software.
Solution freq. is 2.4GHz
Substrate- FR4 Epoxy
With reference to the fig, I need the value of W and the feed length
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.