Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
So I can define the output i want for my system according to my own equation?
And set the control gains and parameter from there?
- - - Updated - - -
The setting of the heater duty cycle refers to varying the voltage being supplied to the heater is that correct?
I see, so its normal the dc gains changes with a different value of step input that I use?
Yes thermal conductance, resistance, heat capacity has been considered and accounted in the equation.
What I am wondering is the a different value of dc gains from the experiment as I increased the value...
Hi
The output for my thermal system is the temperature(degree celcius), while the input to the system is power(watt). I set up this control system, and I am now confused while trying to find the DC gain of the system as it is not the same DC for different value of input into the system.
Is...
Do you mean the loss of heat through the wires that can result in the inaccuracy in the reading?
Yes the sensors are actually planted to measure the temperature of a heat source and they should measure the same temperature or very close. The difference in temperature should only be due to the...
Ok. So I have to use a good reference for the calibration to offset the variation from the accurate temperature right?
This could be a little difficult as the sensors are currently being installed into the structure.
I would have to see what can be done then.
Regards
The 2 sensors are HEL-705-U-1-12-00 and 192-103LET-A01, RTD and thermistor.
Right now I have not gone over a temperature of 100degrees celcius so it should not be out of the tolerance.
Hi
I am working with 2 different temperature sensors. One of them is a themistor and the other is a RTD. I put them in the same place and the temperature that they both measured differed in 0.1degrees celcius which is good enough I think.
However, when the temperature rises to 50degrees then...
Ok. I shall try and narrow it down and see what is causing the problem.
I am guessing it could be memory overun as it is happening at the same time always.
Regards
Yes its strange and actually I do not want it to be this way. As it would obstruct the normal working of the main board causing problems when debugging the project.
So now I have to disconnect the UART and debug the project and connecting it back after the debugging started and connect it...
Hi
I have realized that my PCB board containing the pic33ep512MU814 remained power on as the LED can still be seen lighted after I have removed the power supply.
Another board which is a slave to the main processor is connected to the main board through UART and it is still powered on.
I...
Hi
The MCU is pic33ep512MU814 and it is being compiled and debugged using MPLABX and XC-16.
I have set it up in a while loop with a timer interrupt to handle some processes.
The program is able to run normally when it is being debugged but it is halted due to a break in user code after 100...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
