Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by urja

  1. U

    EKIT01-hMCAD1511 power supply

    Hi! I have read HMCAD1511 and EKIT01-HMCAD1511 datasheets but I still haven't gotten to read with the ADC. Could someone tell me what VCMEXT (JP2) is?
  2. U

    EKIT01-hMCAD1511 power supply

    Hi, Would be possible to power the board using the VCNEXT and GND pins of the J2 connector, instead of using VDD_3V3 pins ? Thaks
  3. U

    EKIT01-hMCAD1511 power supply

    Hi Klaus, No. I have a Enclustra Mercury PE1+ SA2. I have designed a VHDL code and now I'm trying to make the connections. Which is the 3V input in the EKIT01-HMCAD1511? What pin should be connected to 3V? Thanks.
  4. U

    EKIT01-hMCAD1511 power supply

    Thanks for your support! That's what the EKIT01-HMCAD1511 manual tells about the voltaje: In addition, on the schematics of the board, we can see how some FMC pins connect to 3V. Do you think that each of these pins must be connected to 3V, or are they pins from which we can take 3V?
  5. U

    EKIT01-hMCAD1511 power supply

    Hi, I have an EKIT01-HMCAD1511 evaluation board. I have a question about how to power it. I have investigated, and I think it must be done with a 1V8 voltage. I would like you to help me defining the correct way to power this evaluation board.
  6. U

    Program my FPGA with a no volatile file.

    Thanks for your support! And do you know if it´s possible to program using Enclustra Module Configuration Tool?
  7. U

    Program my FPGA with a no volatile file.

    Hi! I have worked with a DE10-NANO, modifying the MSEL and creating a .jic file, based on a .sof, I managed to load the .jic file into the FPGA. This file enabled that when turning off the FPGA the programmed file would not be erased, and when turning it on again the program began to work by...
  8. U

    [SOLVED] ALTLVDS_RX inclock pin. Dedicated clock port?

    I'm designing an FPGA, using Enclustra Mercury PE1 and SA2. The FPGA is Cyclone V ST D6. I'm trying to assign the data entry and clock pins. Someone knows if it is possible to connect the inclock input to any differential I/O. Or do I have to use dedicated clock pins (clk[0..7])? Attach the...
See more

Part and Inventory Search

Back
Top