Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I am trying to write verilog-A code to model a circuit .
I want to generate a square wave . Fot 0 to T(time) output should be low and for T to T1 time output should be high and it repeat .
Here is the code, however it doesn't seem to work.
Any help?
module Neuron16Jan(IN1,IN2,R1,G1)...
Hello,
I am trying to write verilog-A code to model a circuit that acts as an analog timer.
By default, the output is low .Then calculate time (t) and the output should be high for a constant time (t+delt) then it goes low again and repeat it
Any help?
module Neuron16Jan(IN1,IN2,R1,G1)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.